Selection standards for gas pressure reducing valves
1. Within the given spring pressure level range, the outlet pressure can be continuously adjusted between the maximum and minimum values without jamming or abnormal vibration;
2. For soft sealed pressure reducing valves, there must be no leakage within the specified time; For metal sealed pressure reducing valves, the leakage should not exceed 0.5% of the maximum flow rate;
3. The deviation of direct acting outlet pressure shall not exceed 20%, and the deviation of pilot type outlet pressure shall not exceed 10%. When the outlet flow rate changes;
4. The deviation of direct acting outlet pressure shall not exceed 10%, and the deviation of pilot type outlet pressure shall not exceed.
5. when the inlet pressure changes;Generally speaking, the pressure behind the pressure reducing valve should be less than 0.5 times the pressure before the valve;
6. Pressure reducing valves have a wide range of applications, which can be used in equipment and pipelines for steam, compressed air, industrial gases, water, petroleum, and many other liquid media. The mass of the medium flowing through the outlet of the pressure reducing valve is usually expressed as mass flow rate or volume flow rate;<p>
7. Low pressure, medium, and small diameter steam media are suitable for bellows direct acting pressure reducing valves;
8. Medium to low pressure, medium to small diameter air and water media are suitable for diaphragm direct acting pressure reducing valves;
9. Steam, air, and water media of various pressures, calibers, and temperatures are suitable for pilot piston pressure reducing valves.If made of stainless and acid resistant steel, it can be applied to various corrosive media;
10. Pilot operated bellows pressure reducing valve, suitable for low pressure, medium and small diameter steam, air, and other media;
11. Pilot diaphragm pressure reducing valve, suitable for low pressure, medium pressure, medium and small diameter media such as steam or water;
12. The inlet pressure fluctuation of the gas pressure reducing valve should be controlled within 80% -105% of the given inlet pressure value. If the range is exceeded, the initial performance of the pressure reducing valve will be affected.
13. Generally, the pressure behind the gas pressure reducing valve should be less than 0.5 times the pressure before the valve;
14. Each spring of the gas pressure reducing valve can only be used within a certain outlet pressure range. If it exceeds this range, it should be replaced.
15. Generally, pilot operated piston pressure reducing valves or pilot operated bellows pressure reducing valves are used when the working temperature of the medium is high.
16. Usually suitable for using direct acting membrane pressure reducing valves or pilot membrane pressure reducing valves, when the medium is air or water (liquid);
17. Pilot piston type or pilot bellows pressure reducing valve should be selected, when the medium is steam;
18. Pressure reducing valves should usually be installed on horizontal pipelines for easy operation, adjustment, and maintenance,.